Your browser is out of date.

You are currently using Internet Explorer 7/8/9, which is not supported by our site. For the best experience, please use one of the latest browsers.

Request a Quote
banner

Gladiator G3 Microwave Switch

Gladiator G3 Microwave Switch

The Gladiator Gen 3 Microwave Switch can be used for blockage detection, barrier detection, machine detection, collision detection for protection, point level measurement, and detection of objects or material between two points.

Industries

Principle of Operation

A beam of microwave energy passes from a sender unit to a separate receiver in bursts approximately 200 times per second. If the path between the sender and receiver is blocked by any object or material which absorbs or reflects microwave energy, then the receiver will not be able to detect the signal. The presence or absence of the signal at the receiver is used to switch a relay for indication or control purposes.

Certifications

  • IECEx Zone 20/21, Zone 21
  • Ex ta tb IIIC T* Da Db Tamb -30°C to +80°C / Tamb = -30°C to +55°C (model dependent)
  • IP66
  • State of the art Circular transmission
  • Backwards compatible with all Gladiator Microwave generations
  • LCD push button setup / diagnostics on remote amplifier
  • Simple sensitivity adjustment and calibration on Integral system
  • Ranges up to 1200 meters (3937 ft)
  • Tank or Vessel

Measuring Range: 10cm (4in) - 1200m (3937ft)

Communications: GosHawk, Modbus, Modbus over Ethernet TCP/IP, 4-20mA

Maximum Operating Pressure: 6 Bar

Mounting: 3.5" male NPT thread or four 10mm (0.4") holes in flange, MA12 / MA13 adjustable mounting bracket

Contact Us

We will respond to all messages within 24 hours

USA: +1 (888) 429-5538 AU: +61 (0)3 9873 4750